Brush Holder

I used to have different kind of brush holder, but it was tedious to use as you had to concentrate when putting brush back to get it fit correctly. I then chanced to just a normal cup, but from that it's hard to pick just the right brush and you can't see all choices, when they are all clumped together. So I designed this from starting points that brushes has to be easy to pick, easy to put back, you can see all the brushes and it would not take too much table space.

My own print did fail a bit, as I didn't have enough filament on that roll and forgot to check the progress, but the print was about 95% ready so that is good enough for me.

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

0.2

Infill:

Notes:

With 60mm/s speed, 0.3mm layer height and 2 wall lines, this takes over 13 hours to print. Over 4 hours of that is retractions, which is because the form is made by free hand. It was originally over 26 hours, but I cleaned it up a bit. I know it's not optimal model, if this would be made with a script, printing time could come as down as 7 hours.

Takes 122g of filament (41m).

Category: Art Tools