Super Low Profile TUSH - Spool Holder (20x5.5cm)

This is designed for Colorfabb / Filamentum 750gr spools. They have a 20cm diameter and 5.5cm width. Feel free to ask for a specific size if you like the design.

After having tried a few TUSH designs, I found that they are generally a little unstable and will sag under heavy load. I also needed as low a profile as possible.

I designed this to be stronger than you'll ever need and run smooth while avoiding sag after long term use. The spool sits 5mm above the floor.

Print 1 main body and 4 bearing holders.

You need the following to put it together:

4x 608 Bearing

4x M4 nut

4x M4x18 (or longer)

4x M4 washer (not required)

UPDATE 31.08.2018 - I smoothed out the design of the holder and reduced the plastic used quite a bit while maintaining the rigidity

Print Settings

Printer Brand:

Prusa

Printer:

Rafts:

No

Supports:

Resolution:

0.2mm

Infill:

Category: 3D Printer Accessories