Eagle Eye 22mm Dual LED Light Mount

This model is for mounting 2x “Eagle Eye” 22mm diameter LED lights. I designed this for mounting 2x red lights to the rear of my SYL-08 board to act as tail lights. Uses 2x #6x1/2" screws for mounting. Printed mine in Polycarbonate, but PLA is fine as these Red LEDs don't go above ~50°C ambient.

These Eagle Eye LEDs can be found everywhere from Amazon to AliExpress.

Print Settings:

Print on its side with supports on the overhang side of the middle support. A brim is recommended for bed adhesion due to the high aspect ratio of the part.

Reference the image below;

NOTE: The red 3D printed fan blades connected to my motors, collide with this light mount when turning sharply. I ended up removing them as my motors weren't getting very hot, but I may redesign this mount eventually to accommodate them.