Modular filament waste bin system

UPDATE:

Optimized and fast printing version can be find here.

This is a modular variant of the Filament waste system. 

It consists of two parts - a fixed chute and a detachable bin. This is very useful if your setup is situated on a narrow place like box or cabinet.

Тhe connection between the chute and the bin is made by using six neodymium magnets, so you can just pull it up and trow the garbage. The chute is attached to the 3D printer with a screw and two magnets. Additionally you can use three more magnets for securing the bin to the printer (works only with X1C). 

Variants:

1. With duct like here;
2. Without the duct;
3. With the taller bin if the printer is situated on a slab (see videos & photos);
4. With the shorter bin - this is the most common situation.

BOM:

1. Neodymium magnets, totall of 13 pcs. Ø 10x1.5 mm (six of them are mandatory);
2. Screw M3x8 mm, 1 pcs (2 pcs if you decide to print the duct). The screws replace the original ones of the Purge Chute;
3. Some instant glue.