November 27, 2021
Description
Instruktion:
please print the testfile at first: all joints should be moveable without brute force.
If the joints not moveable scale the model up;
If the joints too loose, scale the model a little bit down.
0.5% or 1% up or down should be enough!
Settings:
no raft, so support
I print the dragon 5° Celsius over the usual temeratur to get a good layer adhesion.
4 outer-, top- and bottom layers.
The best result I got with layerhigh from 0.16mm or lower but it works with 0.2mm too.
The first 20% of the print; I slow down the printspeed at 75% to manage the overhangs well.
Watch the testfile, depend on your printer and/or material you have to slow down the speed more at the first 20/25%.
After the print move carefully the joints, especially the neck on the bodyside(up and down) and the first joint of the tail are a little bit delicate.
On the neck there are two stop-points, so the first movement will be a little bit rough.
The tail has one stop-point.
License:
Creative Commons — Attribution — Noncommercial — NoDerivatives
Merandey
