Mean Well LRS-200-XX PSU DIN-Rail Mount

My upgraded 350 sized Voron V2.4 Electronics Bay Layout needed a way to mount the suggested Mean Well LRS-200-24 PSU across two DIN-Rails.

The two Mounts need to be printed on their Sides and like the Original Design should be attached to the PSU using M4x6mm Screws ( Socket Head Cap / Button Head Cap ).

Once on the PSU you just slide the Assembly onto the DIN-Rail into the direction of the Release Flaps ( the downward bent area with the Triangle on them ) while pushing down on the PSU in that area to overcome the Bend used to prestress the Locking Function.

To release the Assembly from the DIN-Rail raise the Release Flaps enabling it from being slid back out again.

Word of Caution:
This Design requires the distance between the DIN-Rails to be of proper length!
Too far apart and the rear Hook will prevent the Locking Mechanism from properly seating onto the front Rail.
Too close together and the rear Hook might not catch.
As such perhaps consider using the Mounts themselves with setting up the required distance between the DIN-Rails.