Summary

Tray to store tools, pens, paint brushes etc.
The tray has a slight tilt with the upwards side open, allowing you to store longer items without them falling out - this also make pens etc. much easier to pick up as you can do it from the short end.

Each slot is 12mm wide, but due to the open design you can easily place larger diameter items in them. You can also scale the entire model in any direction if you need smaller or larger variants.

I have made a few different sizes (5, 10, 15 & 20 slots) that should fit most people's needs and printer sizes.

Print Settings

Printer:

RigidBot

                                            <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.2</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>10%</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Due to the gradient curves, only a very low infill is needed, if at all.</p><p>I printed the model seen in the picture (tool_tray_v2-X20.stl) att 100mm/s with 0.15 layer height and infill at 10% which was plenty. No post-printing cleanup was done before shooting the pics.</p><p>0.2 resolution is enough, but higher resolution will make the slots smoother.</p></div>

Tool / Pen / Brush Tray (multiple sizes)

Tool / Pen / Brush Tray (multiple sizes)

Related Models