Creality Spool Holder - 70mm Spool Adapter & Mods

Timelapse here: https://www.youtube.com/watch?v=n-kSJJgSCzg

Really liked this spool holder by WSmitty1. Made a few changes though.

70mm Spool Adapter - Created this to accommodate spools with much larger holes. I leave them on at all times, they fit very snug and sortof snap into place. Only required if you don't want to reprint the original part. (Spool Adapter Remix- Large Spool AddOn.stl)

Spool holder mod - Cutout a thin layer on the inside, except for two rings near each end. Significantly reducing contact area, therefore friction. (Spool Adapter Remix - Reduce contact.stl)

Shim mod - Spool Adapter Remix - Single Shim.STL combines two shims to wrap about 3/4 around the rod. This flexes enough to securely clip on, so they don't fall off when removing the spool, and don't require glue.